The new Power Commander V is loaded with tons of new features.
Reduced size from PCIIIusb (less than half of the size of PCIII)
USB powered from computer (9volt adapter is no longer needed for programming)
2 position map switching function built in (map switch no included)
Gear input (allows for map adjustment based on gear and speed)
Analog input (allows used to install any 0-5 volt sensor and build and adjustment table based on its input such as boost or temperature)
With gear position input connected the PCV is capable of allowing each cylinder to be mapped individually and for each gear (for example: on a 4 cylinder bike with a six speed transmission there could be up to 24 separate fuel tables)
Unit has a -100/+250% fuel change range (up from -100/+100%). This allows more adjustment range for 8 injector sportbikes
10 throttle position columns (up from 9 on PCIIIusb)
Enhanced accel pump utility (increased adjustment and sensitivity ranges)
Included Items: (1) Power Commander V with wire harness includes (4) male two pin connectors, (4) female two pin connectos, (1) male three pin connector, (1) female three pin connector and (1) ring terminal (1) 6' usb cord (1) O2 optimizer (3) Black rubber plugs (2) 5/8 in. x 2 in. adhesive back Velcro (1) Alcohol prep pad Instructions and a manual
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.