Fuel control for each individual cylinder in a smaller enclosure
"Warm-up" fuel adjustment (unit reads engine temp and allows fuel/timing adjustments based on the reading)
Reduced size from the PCIII USB
Easy to install
USB powered from computer; 9 volt adapter is no longer needed
Two-position map-switching function built in
Can add any Single Pole Single Throw (SPST) switch and toggle between two different fuel maps
Gear/speed input allows for map adjustment based on gear
Analog input allows user to install any 0-5 volt sensor
Build an adjustment table based on analog input such as boost or temperature
Power Commander V is capable of allowing each cylinder to be mapped individually and for each gear with the gear position input connected
More tuning ranges than PCIII USB
Enhanced "accel pump" utility
Made in the U.S.A.
NOTE: May not be legal for street use in CA.
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.