Fuel control for each individual cylinder in a smaller enclosure
Warm-up fuel adjustment (unit reads engine temp and allows fuel/timing adjustments based on the reading)
Reduced size from the PCIII USB
Easy to install
USB powered from computer; 9 volt adapter is no longer needed
Two-position map-switching function built in
Can add any Single Pole Single Throw (SPST) switch and toggle between two different fuel maps
Gear/speed input allows for map adjustment based on gear
Analog input allows user to install any 0-5 volt sensor
Build an adjustment table based on analog input, such as boost or temperature
With the gear position connected, Power Commander V is capable of allowing each cylinder to be mapped individually for each gear
More tuning ranges than PCIII USB
Enhanced accel pump utility
Made in the U.S.A.
Included Items: (1) Power commander V with wire harness includes (4) male two spade connectors, (4) female two spade connectors, (2) Bare wires and (1) ring terminal (1) 6' usb to mini usb cable (2) Posi-tap (3) Black rubber plugs (2) 5/8 in. x 2 in. adhesive back velcro (1) Alcohol prep pad Instructions and a manual
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
