Overview of Dynojet Power Commander Fuel Controller - FC22901
|The Power Commander FC is a new plug-n-play fuel management device pre-programmed with Make/Model specific maps. In addition the Power Commander FC has the added ability to modify or change these maps on the fly without a computer.
Users can literally select between a Power Commander FC Map, custom-built maps, or even fine tune low, mid or high rpm ranges while sitting on the bike and without plugging into a computer. Standard +/- 10% increments from selected map settings, different ranges are available using the supplied Control Center software.
Users can also load up to 10 of their personally built Power maps into the Power Commander FC and select between them while in the saddle - eliminating the need to re-boot with the computer every time a new map is desired.
(1) Power commander FC with wire harness includes (1) Male four pin connector, (1) Female four pin connector
(1) Male two pin connector
(1) Female two pin connector, (1) Ring terminal and (1) Bare wire
(1) 6' USB to mini USB cord
(2) 5/8 in. x 2 in. adhesive back velcro strips
(1) Alcohol prep pads
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
Cross reference number(s):10202329
Specs for Dynojet Power Commander Fuel Controller - FC22901
|Type||Fuel Injection Module|
Fitment for Dynojet Power Commander Fuel Controller - FC22901See if this part fits your ride
Part 2002023 fits the following machines
- 2014 Yamaha YW125 Zuma
- 2013 Yamaha YW125 Zuma
- 2012 Yamaha YW125 Zuma
- 2011 Yamaha YW125 Zuma
- 2010 Yamaha YW125 Zuma
- 2009 Yamaha YW125 Zuma