The Power Commander FC is a new plug-n-play fuel management device pre-programmed with Make/Model specific maps. In addition the Power Commander FC has the added ability to modify or change these maps on the fly without a computer.
Users can literally select between a Power Commander FC Map, custom-built maps, or even fine tune low, mid or high rpm ranges while sitting on the bike and without plugging into a computer. Standard +/- 10% increments from selected map settings, different ranges are available using the supplied Control Center software. Users can also load up to 10 of their personally built Power maps into the Power Commander FC and select between them while in the saddle - eliminating the need to re-boot with the computer every time a new map is desired.
NOTE: Dynojet does not offer a supported Map Database for snowmobile Power Commanders. Contact them direct at 800-992-4993 for assistance Note: This unit does NOT work with any of the Dynojet accessories - SFM, Ignition module, shifter, LCD Included Items: (1) Power Commander FC includes, (4) male two pin connector, (4) female two pin connector, (1) male three pin connector, (1) female three pin connector and (1) ring terminal (1) 6' USB to mini USB cable (2) 5/8 in. x 2 in. adhesive back velcro (1) Alcohol prep pad (3) 7 3/4 in. black plastic wire ties Instructions All sales are final on fuel processors/tuners, no returns accepted. For warranty related issues, please contact manufacturer directly. The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California. |
Mfg #: | FC22038 |
---|---|
Part #: | 2002034 |
Type | Fuel Injection Module |
Units | Each |
Weight | 0.80 lbs |
Part 2002034 fits the following machines