Overview of Dynojet Power Commander Fuel Controller - FC20010
|The Power Commander FC is a new plug-n-play fuel management device pre-programmed with Make/Model specific maps. In addition the Power Commander FC has the added ability to modify or change these maps on the fly without a computer.
Users can literally select between a Power Commander FC Map, custom-built maps, or even fine tune low, mid or high rpm ranges while sitting on the bike and without plugging into a computer. Standard +/- 10% increments from selected map settings, different ranges are available using the supplied Control Center software.
Users can also load up to 10 of their personally built Power maps into the Power Commander FC and select between them while in the saddle - eliminating the need to re-boot with the computer every time a new map is desired.
Note: This unit does NOT work with any of the Dynojet accessories - SFM, Ignition module, shifter, LCD
Power Commander FC with wire harness includes: (1) Power Commander FC with (4) female two pin connectors, (4) male two pin connectors, (1) ring terminal and (1) bare wire
(1) O2 optimizer
(1) 6' usb to mini usb cable
(2) 5/8 in. x 2 in. adhesive back vcelcro strips
(1) Alcohol prep pad
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
Cross reference number(s):10202181
Specs for Dynojet Power Commander Fuel Controller - FC20010
|Type||Fuel Injection Module|
Fitment for Dynojet Power Commander Fuel Controller - FC20010See if this part fits your ride
Part 2001864 fits the following machines
- 2009 Suzuki GSF1250S Bandit S
- 2008 Suzuki GSF1250S Bandit S
- 2007 Suzuki GSF1250S Bandit S
- 2012 Suzuki GSX1250FA
- 2011 Suzuki GSX1250FA