Overview of Dynojet Power Commander Fuel Controller - FC16013
|The Power Commander FC is a new plug-n-play fuel management device pre-programmed with Make/Model specific maps. In addition the Power Commander FC has the added ability to modify or change these maps on the fly without a computer.
Users can literally select between a Power Commander FC Map, custom-built maps, or even fine tune low, mid or high rpm ranges while sitting on the bike and without plugging into a computer. Standard +/- 10% increments from selected map settings, different ranges are available using the supplied Control Center software.
Users can also load up to 10 of their personally built Power maps into the Power Commander FC and select between them while in the saddle - eliminating the need to re-boot with the computer every time a new map is desired.
Note: This unit does NOT work with any of the Dynojet accessories - SFM, Ignition module, shifter, LCD
(1) Power Comander FC with wire harness includes (1) ring terminal, (4) female two pin connectors, (4) male two pin connectors, (1) female three pin connector and (1) male three pin connector
(1) 6' usb to mini usb cable
(1) O2 optimizer
(2) 5/8 in. x 2 in. adhesive back velcro
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
Cross reference number(s):10202157
Specs for Dynojet Power Commander Fuel Controller - FC16013
|Type||Fuel Injection Module|
Fitment for Dynojet Power Commander Fuel Controller - FC16013See if this part fits your ride
Part 2001839 fits the following machines
- 2016 Honda CB1000R
- 2015 Honda CB1000R
- 2014 Honda CB1000R
- 2013 Honda CB1000R
- 2012 Honda CB1000R
- 2011 Honda CB1000R