These Legacy style gas tanks are Peanuts with an attitude. The side indents look so good, that you don't even care about their capacity. These tanks for custom applications have no mounts fitted and come with 3-piece weld-on mounting bracket & bushing kits. Screw-in style gas tanks take stock screw-in gas cap and consequently any aftermarket screw-in gas cap designed for stock gas tanks. Legacy Lynx tanks have a non-stock style bung and come complete with a Lynx style gas cap. Tank is 52cm long, has a 27cm front width, 20cm front height, and an 8cm wide tunnel.
To add a real piece of classic comfort we have a straight fit rubber knee pad set available too.
Custom gas tanks for carburetor equipped bikes
Ready to take a stock style fuel valve left or right. Chrome block-off nut for the un-used fuel valve opening included
Length: 21 in.
Front: 2 1/4 in.
Front: 3 3/4 in.
Fuel Petcock: Left center/Right Center
Petcock Thread Size: 22mm
Gas Cap Type: Threaded
Fuel Pump Tabs: No
(1) Gas tank
(1) Aluminum gas cap
(1) 22mm bung cap
(2) Weld on L-brackets
(1) Weld on straight brackets
(4) Rubber grommets
(6) 5/16 in. flat washers
(2) 5/16 in. split lock washers
(2) 5/16 in.-24 hex nuts
(1) 5/16 in.-24 x 3 1/8 in. hex head bolt
(1) 5/16 in.-24 x 3 1/2 in. hex head bolt
(1) 5/16 in.-24 x 4 1/2 in. hex head bolt
|Color - Primary||Silver|
|Thread Size||22 mm|
Part 188149 fits the following machines