Recalibration kit gives your machine more performance when using a Cobra Boulevard exhaust and a stock or aftermarket air filter
All necessary hardware and instructions included
Designed by DynoJet
CAUTION: These systems are NOT emissions-approved and are intended for racing applications only
Legal in California only for racing vehicles that may never be used on a public highway
Included Items: (3) Main jets(128,130,132)
(1) Fuel needle
(1) Adjusting washer
(1) Slide spring
(1) Needle spring
(1) Plug drill
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
If you are running an aftermarket exhaust, this kit is a must have. I installed this in my wifes bike last weekend. It is less cold natured, has crisper throttle response, and she swears it has more power.
What can I say, its a jet kit. If you haven't done this before I would recommend getting instructions for carburetor removal. Instructions for installing the jet kit are ok. Along with new pipes it really helped with performance.
this was just what my 2004 vtx 1300c with cobra slipons needed to run the way the factory should have had it running easy to tune and install if you follow the directions and have a basic knowledge of a carb
With a little help from Youtube and the shop manual I had no problem at all installing this kit, even though I am fully aware the word "Carburator" is French for "Don't mess with it." When I first installed the Cobra Drag Pipes on my 2006 Honda VTX 1300c I thought I had gotten away with skipping the Jet Kit, but deceleration backfires proved otherwise. This kit did the job! And as always, thanks to Dennis Kirk for their OUTSTANDING service in getting the parts to me quickly, I am always amazed by them!