Overview of Cobra Slash-Down Hot Rod Speedster Exhaust - 4823
- Addition of PowerPort headpipe increases overall performance
- 2 1/2 inch, 222 degree full-length heat shields fit tip-to-tip
- Beautiful machined billet end caps produces a great look for your bike
- Best fit and finish exhaust on the market
For replacement baffle use 44-02771 and for quiet baffle use 44-02772
Oxygen sensor eliminator part no.20-1032 is required for California and European models.
(1) Front Exhaust Assembly
(1) Rear Exhaust Assembly
(5) Hose Clamps
(2) Exhaust Flanges
(2) Hex Bolts (5/16-18 x .63)
(2) Button Screws 1/420 x .38)
(2) Billet Muffler Tips
Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information.
Installation of a new exhaust system may change your motorcycles fuel-air mixture. Please consult the exhaust manufacturer directly with questions regarding any modifications that may be made during, or after, installing their product. If a jet kit or Power Commander is recommended, see the Intake/Fuel section
Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing, therefore is not covered by any warranty. See Chems/Lubes section for products to help remove or prevent exhaust discoloration.
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
Specs for Cobra Slash-Down Hot Rod Speedster Exhaust - 4823
|Color - Primary
Alternate/OEM Part Number(s):