Overview of Cobra Slash-Down Hot Rod Speedster Exhaust - 2822
- Addition of PowerPort headpipe increases overall performance
- 2 1/2 inch, 222 degree full-length heat shields fit tip-to-tip
- Beautiful machined billet end caps produces a great look for your bike
- Best fit and finish exhaust on the market
For replacement baffle use 44-02771 and for quiet baffle use 44-02772
NOTE: System includes oxygen sensor bungs; installed.
(1) Front headpipe w/heatshield
(1) Rear headpipe w/heatshield
(1) Exhaust bracket
(2) Exhaust flanges
(4) Smaller Hose clamps
(2) Larger hose clamps
(2) 27-61 Clamps
(2) 5/16-18 x .63 in. Hex bolts
(2) 1/4-20 x .38 in. Button screws
(2) M10 x 30mm Allen bolts
(2) M10 Nylock nuts
(2) Billet muffler tips
(1) O2 sensor harness ext.
Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information.
Installation of a new exhaust system may change your motorcycles fuel-air mixture. Please consult the exhaust manufacturer directly with questions regarding any modifications that may be made during, or after, installing their product. If a jet kit or Power Commander is recommended, see the Intake/Fuel section
Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing, therefore is not covered by any warranty. See Chems/Lubes section for products to help remove or prevent exhaust discoloration.
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
Specs for Cobra Slash-Down Hot Rod Speedster Exhaust - 2822
|Color - Primary
Alternate/OEM Part Number(s):