Overview of Cobra Hot Rod Speedster Slash-Down Exhaust System - 3823
- Addition of PowerPort headpipe increases overall performance
- 2 1/2 in., 222 degree full-length heat shields fit tip-to-tip
- Beautiful, machined billet end caps produce a great look for your bike
- Best fit and finish exhaust on the market
- Removable baffles
- Made in the U.S.A.
For replacement Baffle use 44-02773 and for Quiet Baffle: 44-02774
(1) Front headpipe w/heatshield
(1) Rear headpipe w/heatshield
(1) Muffler assembly
(1) Exhaust mount bracket
(2) Exhaust flanges
(2) 5/16-18 x 5/8 Hex bolts
(1) M8 x 16mm Hex bolt
(1) M8 x 25mm Hex bolt
(2) 27-61 Clamps
(4) Small hose clamps
(2) Large hose clamps
(2) Exhaust tips
(2) 1/4-20 x 3/8 in. Buttonhead bolts
NOTE: Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and manufacturers information.
Installation of a new exhaust system may change your motorcycles fuel-air mixture requirements. Please consult the exhaust manufacturer directly with questions regarding any modifications that may need to be made during, or after, installing their product. If a jet kit or fuel processor is recommended, see the Intake/Fuel section.
Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing; therefore it is not covered by warranty. See the Chems/Lubes section for products to help remove or prevent exhaust discoloration.
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
Specs for Cobra Hot Rod Speedster Slash-Down Exhaust System - 3823
|Color - Primary
Alternate/OEM Part Number(s):