Overview of Cobra Hot Rod Speedster Slash-Down Exhaust System - 1831
- Addition of PowerPort headpipe increases overall performance
- 2 1/2 inch, 222 degree full-length heat shields fit tip-to-tip
- Beautiful, machined billet end caps produce a great look for your bike
- Best fit and finish exhaust on the market
- Removable baffles
- Made in the U.S.A.
For replacement baffle use 44-03615 for quiet baffle use 44-02772
Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and manufacturers information.
Installation of a new exhaust system may change your motorcycles fuel-air mixture requirements. Please consult the exhaust manufacturer directly with questions regarding any modifications that may need to be made during, or after, installing their product. If a jet kit or fuel processor is recommended, see the Intake/Fuel section.
Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing; therefore it is not covered by warranty. See the Chems/Lubes section for products to help remove or prevent exhaust discoloration.
(1) Front headpipe w/heatshield
(1) Rear headpipe/muffler w/heatshield
(1) Exhaust bracket
(2) Billet muffler tips
(1) Regulator bracket
(5) Hose clamps
(1) 27-61MSC Clamp
(3) 5/16-18 Hex bolts
(2) 6mm x 20mm Hex bolts
(2) 1/4-20 Button screws
(1) M10-1.25 x 80mm Bolt
(1) M10-1.25 x 60mm Bolt
(1) M10-1.25 Nylock nut
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
Specs for Cobra Hot Rod Speedster Slash-Down Exhaust System - 1831
|Color - Primary
Alternate/OEM Part Number(s):