Overview of Cobra Dragster Exhaust System - 2627
- Maintains clean, pure traditional drag-pipe look
- Full-length, 2.75 in. heat shields
- 222 degrees wraparound for a non-bluing appearance
- Beautifully machined and chromed billet tips
- Removable baffles
- Easy to install
- Made in the U.S.A.
For replacement baffle use 44-03617
NOTE: System includes oxygen sensor bungs
(1) Front headpipe w/heatshield
(1) Rear headpipe w/headshield
(1) Exhaust-mounting bracket
(4) Hose clamps HS-24
(3) Hose clamps HS-28
(4) Bolts, hex 5/16-18 x 5/8
(2) Buttonhead screws 1/4-20 x 3/8
(2) Billet muffler tips
Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information.
Installation of a new exhaust system may change your motorcycles fuel-air mixture. Please consult the exhaust manufacturer directly with questions regarding any modifications that may be made during, or after, installing their product. If a jet kit or Power Commander is recommended, see the Intake/Fuel section
Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing, therefore is not covered by any warranty. See Chems/Lubes section for products to help remove or prevent exhaust discoloration.
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
Specs for Cobra Dragster Exhaust System - 2627
|Color - Primary
Alternate/OEM Part Number(s):