Overview of Cobra Slash-Cut Tips Exhaust System - 1675SC
NOTE: Three-piece heat shield kit included
California/Euro models require oxygen sensor eliminator kit Part No. 447234
(1) Front exhaust assembly
(1) Rear exhaust assembly
(1) Regulator bracket
(4) 5/16x5/8 in. Hex bolts
(1) 10mm Fine thread bolt
(1) 10mm Spring washer
(1) 3/8-16x1 in. Hex bolt
(1) 3/8 in. Nut
(1) 3/8 in. Washer
(2) Slider brackets
Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information.
Installation of a new exhaust system may change your motorcycles fuel-air mixture. Please consult the exhaust manufacturer directly with questions regarding any modifications that may be made during, or after, installing their product. If a jet kit or Power Commander is recommended, see the Intake/Fuel section.
Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing, therefore is not covered by any warranty. See Chems/Lubes section for products to help remove or prevent exhaust discoloration.
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
Cross reference number(s):BLV1675SC
Specs for Cobra Slash-Cut Tips Exhaust System - 1675SC
|Color - Primary||Chrome|
Fitment for Cobra Slash-Cut Tips Exhaust System - 1675SCSee if this part fits your ride
Part 431130 fits the following machines
- 2007 Honda VTX1800C
- 2006 Honda VTX1800C
- 2005 Honda VTX1800C
- 2004 Honda VTX1800C
- 2003 Honda VTX1800C
- 2002 Honda VTX1800C
- 2008 Honda VTX1800F
- 2007 Honda VTX1800F
- 2006 Honda VTX1800F
- 2005 Honda VTX1800F
10 months ago