(1) Front headpipe/heatshield
(1) Rear headpipe/heatshield
(1) Exhaust mounting bracket
(1) Muffler assembly
(1) Exhaust valve actuator bracket
(1) Exhaust valve actuator solenoid cam
(2) Headpipe flange
(6) Clamp, HS 24;1 - clamp, HS 28
(2) Clamp 27-61 (muffler clamp)
(2) Aluminum spacer
(2) Bolt, 6mm x 50mm
(4) Bolt, Flange 5/16x5/8 in.
(2) 1/4 in. flat washers
(2) 5/16 in. flat washers
(2) 6mm nuts
(2) 5/16 in. nuts
NOTE: Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and manufacturers information.
Installation of a new exhaust system may change your motorcycles fuel-air mixture requirements. Please consult the exhaust manufacturer directly with questions regarding any modifications that may need to be made during, or after, installing their product. If a jet kit or fuel processor is recommended, see the Intake/Fuel section.
Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing; therefore it is not covered by warranty. See the Chems/Lubes section for products to help remove or prevent exhaust discoloration.
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
Part 4405003 fits the following machines