(1) Front Headpipe/Heatshield
(1) Rear Headpipe/Heatshield
(1) Exhaust Mounting Bracket
(1) Muffler Assembly
(1) Exhaust Valve Actuator Bracket
(1) Exhaust Valve Actuator Solenoid Cam
(2) Flange, Headpipe
(6) Clamps (HS24)
(1) Clamp (HS28)
(2) Clamp (Muffler Clamp)
(2) Spacer, Aluminum
(2) Bolt, 6mm x 50mm
(4) Bolt, Flange 5/16 in. x 5/8 in.
(2) Washer, 1/4 in. Flat
(2) Washer, 5/16 in. Flat
(2) Nut, 6mm
(2) Nut, 5/16 in.
NOTE: Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and manufacturers information.
Installation of a new exhaust system may change your motorcycles fuel-air mixture requirements. Please consult the exhaust manufacturer directly with questions regarding any modifications that may need to be made during, or after, installing their product. If a jet kit or fuel processor is recommended, see the Intake/Fuel section.
Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing; therefore it is not covered by warranty. See the Chems/Lubes section for products to help remove or prevent exhaust discoloration.
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
Part 4405002 fits the following machines