NOTE: Includes O2 sensor plugs for pre-07 applications
NOTE: Includes 18mm to 12mm O2 sensor port adapters
NOTE: Baffles for turn-out systems are welded in place; all others are removable.
NOTES: Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information
There is no warranty on exhaust pipes and mufflers with regard to any discoloration. Discoloration (bluing) is the result of tuning characteristics, cam timing, carburetor jetting, overheating, etc., and is not caused by defective manufacturing. See the CHEMS/LUBES section for products that will help prevent or remove bluing.
Installation of a new exhaust system may change your motorcycles fuel-air mixture requirements. Please consult the exhaust manufacturer directly with questions regarding any modifications that may need to be made during, or after, installing their product. If a jet kit or fuel processor is recommended, see the FUEL/INTAKE section.
(1) Front head pipe
(1) Rear head pipe
(2) Heat shields
(1) Mounting bracket
(3) #24 hose clamp
(3) #28 hose clamp
(2) 3/8"-16 x 1" hex head bolts
(2) 3/8" flat washers
(2) 3/8" Lock washers
(1) 5/16"-18 x 1" hex head bolt
(1) 5/16" flat washer
(1) 5/16"-18 flange nut
(2) 12mm O2 sensor plugs
(2) 18mm to 12mm O2 sensor reducers
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
Part 4406719 fits the following machines