You May Also Be Interested In
Part #: 264183 Mfg Part #: 22899Other People Bought
NOTE: 12-up models require O2 sensor port 18mm to 12mm adaptors - Part No. 44-06482
NOTE: Works with forward controls only
(1) Front head pipe heat shield
(1) Rear head pipe heat shield
(1) Collector heat shield
(1) Front/Rear head pipe assembly
(1) Megaphone muffler w/billet end cap & baffle
(5) #24 Hose clamps
(4) 5/16-18 x 3/4 in. Squarehead bolts
(4) 5/16-18 Flange nuts
(1) Mounting bracket
(1) #36 hose clamp
(1) #27-73 Barrel band clamp
(1) 5/16-18 x 1-3/4 in. Hexhead bolt
(1) 5/16 in. Flat washer
Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information
There is no warranty on exhaust pipes and mufflers with regard to any discoloration. Discoloration (bluing) is the result of tuning characteristics, cam timing, carburetor jetting, overheating, etc., and is not caused by defective manufacturing. See the CHEMS/LUBES section for products that will help prevent or remove bluing.
Installation of a new exhaust system may change your motorcycles fuel-air mixture requirements. Please consult the exhaust manufacturer directly with questions regarding any modifications that may need to be made during, or after, installing their product. If a jet kit or fuel processor is recommended, see the FUEL/INTAKE section.
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
|Color - Primary||Chrome|
Part 4404782 fits the following machines