Our Plug-n-Play DYNAMIC Sequential RBT/Run-Brake-Turn Signal Module will allow riders to install (3) separate (red) LED turn signals (in the rear of the bike) on the left the right side that will sequentially flash when the turn signal button is pressed. The LED’s will also have running light and brake functions with a built in Load Equalizer to prevent rapid flashing turn signals. This unit is 100% solid state with thermal protection and produces virtually zero heat. It comes complete with a color-coded replacement rear fender harness and schematic for easy installation.
Static sequential flashing: When the turn signal button is pressed, the first LED will lite up followed by the second and third before all (3) shut off and the sequence starts again.
(1) Run/brake/turn signal module with wiring harness
(4) Black wires
(1) Purple/black wiring harness
(1) Brown/black wiring harness
(2) Cable ties
(12) 1-1/2" Shrink tubes
(2) Ring terminals
(2) 30" Shrink tubes
Part 2101196 fits the following machines