• Bobbed gas tank is dual cap type for carburetor models.
• It features a left side fuel gauge bung, and a right side screw bung.
• Order gas caps separately.
• Tank is not for fuel injected models.
• Check the tank for flaws and fit before painting.
• It requires sanding and primer.
• Do not grind or sand the seams or joints.
• Check the petcock opening, making sure the petcock can be easily installed.
• The petcock fitting should be masked or plugged during painting for easy installation of the petcock.
• It is suggested to pressure test and use a tank sealer.
• We suggest using Kreem gas tank combo kit to clean, condition and seal to help stop leaks and prevent corrosion.

WARNING:
Check the tank for flaws and fit before painting. The tank requires sanding and primer. Do not grind or sand the seams or joints. The fuel line opening should be masked or plugged during painting for easy installation of the fuel line. Clean the inside of the tank. It is suggested to pressure test the tank and use a tank sealer. We suggest using Kreem gas tank combo kit to clean, condition, and seal to help stop leaks and prevent corrosion.

(1) Raw gas tank

No Instructions

DIMENSIONS

Top Length: 18-1/2"      

Bottom Length: 18-1/4"              

Front Width: 15"   

Rear Width: 9-1/2"                  

Tunnel length: 18-1/2"         

TUNNEL DEPTH

Front: 7"                      

Rear: 1-1/2"                   

Front tank height: 8"    

Rear tank height:2"  

Front bracket width: 3"

Rear bracket width: 2 5/8"

Bracket to bracket Length: 20-3/4"     

Fuel petcock: Left rear        

Petcock thread size: 22mm      

Gas cap type: Threaded         

Fuel pump tabs: No