|
|
|
|
|
|
|
|
$58.95
Moose Side Shield for Cycle Country Plows p512375
Manufacturer: Moose
Dennis Kirk Part #: 512375
Moose Side Shield for Cycle Country Plows: Manufacturer part # p512375 - Greatly reduces the amount of overflowing snow or dirt when used on the forward end of an angled Moose Cycle Country plow blade. A side shield on both ends of a straight blade contains even more plowed material. Easy to install, constructed from sturdy, 11-gauge steel. Measures 14-1/2 in. H x 8 in. W. Requires some drilling for installation. INCLUDED ITEMS: . (1) Instruction sheet. p512375
4 on hand
More Info/Options for Moose Side Shield for Cycle Country Plows p512375
Ultra Cycle
|
|
|
|
$219.95
Moose Ultra Archery Cargo Box RMOSLLD0007B
Manufacturer: Moose
Dennis Kirk Part #: 505815
Moose Ultra Archery Cargo Box: Manufacturer part # RMOSLLD0007B - The ultimate bow and accessory carrier -- fits bows with up to 44" axle-to-axle length with quiver installed. Constructed from durable UV-stabilized polyethylene; cover includes a rubber seal that keeps out water and dust, lockable latches and durable molded-in hinges. Protective, removable foam interior. Cover includes a custom molded basket. Installs on most front and rear racks. Measures 46" W x 22" L x 11" H; capacity: 2.66 cu. ft. inside; 1.15 cu. ft. top. Made in the U.S.A... RMOSLLD0007B
1 on hand
More Info/Options for Moose Ultra Archery Cargo Box RMOSLLD0007B
Ultra Cycle
|
|
|
|
|
|
|
|
|
|
|
|
|
|
$271.99
Pingel Cycle Jaws PCJ1
Manufacturer: Pingel
Dennis Kirk Part #: 282470
Pingel Cycle Jaws: Manufacturer part # PCJ1 - Clamps front tires from 3 in. to 6 1/2 in. W to stabilize the front of a motorcycle for truck or trailer transportation. Easy to operate -- just roll in the motorcycle, leave it in gear and get off. No bulky hardware to ride over for effortless motorcycle removal. Damage to valuable rotors and rims is prevented by the adjustable tire locator. Install or remove it in just minutes from any truck or trailer or use it in your shop on a motorcycle lift or mount it directly to the floor. Constructed from heavy-duty, thick-wall, yellow zinc-plated steel construction for durability. Made in the U.S.A. from American steel.. PCJ1
2 on hand
More Info/Options for Pingel Cycle Jaws PCJ1
Ultra Cycle
|
|
|
|
$227.99
Travelrite Travelrack Cycle Carrier 06046
Manufacturer: Travelrite
Dennis Kirk Part #: 55841
Travelrite Travelrack Cycle Carrier: Manufacturer part # 06046 - Specifically for Class III hitches. Made with aluminum; rails are light and store easily. Two tiedowns and it is firmly in place. Hauls more than the design limit of class III hitches; rated for 400 lbs.. , , NOTE: The tongue weight of a receiver type hitch is rated at the distance the ball normally is from the end of the receiver. Most carriers of this type are about double that distance so the load rating is normally reduced by 1/2. (500 lb. rated hitches will carry approximately 250 lbs.) For questions, contact your hitch manufacturer.. , , Included Items:. , 1. (6) 5/16" ID x 1 1/2" OD x 1/8" thick fender washers. , 2. (6) 5/16-18 x 1" hex head bolts. , 3. (6) 5/16" nylock nuts. , 4. (1) Hitch extension. , 5. (1) Cycle carrier. , 6. (1) Wheel stop. , 7. (1) 1/2" lock washer. , 8. (1) 1/2" hitch pin. , 9. (1) 1/2" hex nut. 06046
1 on hand
More Info/Options for Travelrite Travelrack Cycle Carrier 06046
Ultra Cycle
|
|